In the breeding process of alfalfa, the fermentation process of alfalfa feed (poultry, lees, bagasse, remaining meals, waste blood, and animal internal organs, etc.) is the key. If the feed is not fermented or the fermentation is incomplete, harmful gas will be produced, and the pH may be too high or If it is too low, it may cause the cockroach to escape, not produce or even die. Using EM stock solution for fermentation of manure, the fermentation time of the manure is greatly shortened and the odor is reduced. After the feed is fermented, the pH value will naturally reach 6.5--7.5, and it can be directly fed without increasing the utilization of feed. There are many more pods, faster breeding, and a 2- to 3-fold increase in yield. The method is as follows: (a) Stacks of rice straw, straw (better cuts are better) first spread a layer (10-15 cm thick) of dry material, and then cover the dry material (4-6 cm thick) , Repeatedly laying out layers 3- to 5, spraying water on each layer with a spray bottle (EM raw liquid is added to the dung heap at this time, one ton of manure requires EM10 kg to dilute about 100 kg of water) until the water seeps out. Good; such as the use of garbage, a layer of rubbish a layer of waste, length and width are not limited, and cover the film with strict; if you use 100% of fecal material, the first dung to dry after the five-six percent dry pile, wet with EM water Sealed with film. (II) In the season where the temperature is relatively high, the temperature in the reactor will increase obviously on the second day of the general, and it will rise to 60--70°C in the 4- to 5-day period, and then gradually decrease, when the temperature in the reactor falls to 40°C. When the process takes 12 days, it is turned over. Turn the top down, turn both sides to the middle, and add the EM diluent. In winter, it turns 2 - 3 times and it turns 1 in summer. (3) Feeding Feed After the fermentation is completed, the feed water can be used immediately after being heated to disperse heat. Generally, the method of feeding and side feeding is generally used for feeding, and the method of feeding is used to cover the feed that has been eaten. On the other hand, it is performed once every 10-15 days; the side feeding method is to take out some of the finished feed and add the new feed to one side. The next time you add the other side.
Therapeutic heating pads usually operate from household current and must have protection against overheating.
A moist Heating Pad is used dry on the user's skin. These pads register temperatures from 76 to 82 °C (169 to 180 °F) and are intended for deep tissue treatment and can be dangerous if left on unattended. Moist Heating Pads are used mainly by physical therapists but can be found for home use. A moist cloth can be added with a stupe cover to add more moisture to the treatment.
Image as below:
Therapeutic Heat Pad, Therapeutic Small Electric Heating Pad, Heated Therapeutic Knee Pads, Therapeutic Heat Pad for Shoulder
Ningbo Makeheat Electrical Appliance Co., Ltd , http://www.makeheat.net